Vertical Bendable - Top Light NEON Light Guide .
April, 2025 by Frank
Installation guide - 1010 1212 1616 ... Series vertical bend / Top light NEON Products
Cut material to the length required using Novaneon Shears (cut only at the marked intervals on the underside of the casing).
To connect to power, cut away a short section of the silicone casing to reveal the soldering pad.
Solder the wire tails to the terminals for connection to power supply. Always ensure positive to positive and negative-negative connection.
Seal the wired end: use the end cap with hole & thread the soldered wire tails through. Apply glue to the inside of the end cap, and push onto the LED strip, wiping off any excess glue. Wait for glue to dry before powering on.
To seal terminating end, apply glue to the inside of the end cap and wipe off any excess glue.
When handling the Neonflex, take care to only bend vertically and avoid twisting or stretching the strip, as this may damage the internal components.
What Application of the NEON Flex LED Strip Light ?
The Supaflex Neonflex has been purpose-designed for building and architectural feature lighting applications. Easily cut to your desired size, this 24V LED dotless strip light can be run up to 5m in a single series. With vertical bending capability, the Supaflex Neonflex 1010 1212 1616 1414 is excellent in the following applications:
- Building Feature Lighting
- Architectural Lighting / Mall Shop Lighting
- Indoor and Outdoor
- Dimmable (with controller)
- Outline Decorative Light
More Information about our NEON products :
NEON LED Light
